Testbox Imaging (Backup / Restore) ================================== Introduction ------------ This document is explores deploying a very simple drive imaging solution to help avoid needing to manually reinstall testboxes when a disk goes bust or the OS install seems to be corrupted. Definitions / Glossary ====================== See AutomaticTestingRevamp.txt. Objectives ========== - Off site, no admin interaction (no need for ILOM or similar). - OS independent. - Space and bandwidth efficient. - As automatic as possible. - Logging. Overview of the Solution ======================== Here is a brief summary: - Always boot testboxes via PXE using PXELINUX. - Default configuration is local boot (hard disk / SSD) - Restore/backup action triggered by machine specific PXE config. - Boots special debian maintenance install off NFS. - A maintenance service (systemd style) does the work. - The service reads action from TFTP location and performs it. - When done the service removes the TFTP machine specific config and reboots the system. Maintenance actions are: - backup - backup-again - restore - refresh-info - rescue Possible modifier that indicates a subset of disk on testboxes with other OSes installed. Support for partition level backup/restore is not explored here. How to use ---------- To perform one of the above maintenance actions on a testbox, run the ``testbox-pxe-conf.sh`` script:: /mnt/testbox-tftp/pxeclient.cfg/testbox-pxe-conf.sh 10.165.98.220 rescue Then trigger a reboot. The box will then boot the NFS rooted debian image and execute the maintenance action. On success, it will remove the testbox hex-IP config file and reboot again. Storage Server ============== The storage server will have three areas used here. Using NFS for all three avoids extra work getting CIFS sharing right too (NFS is already a pain). 1. /export/testbox-tftp - TFTP config area. Read-write. 2. /export/testbox-backup - Images and logs. Read-write. 3. /export/testbox-nfsroot - Custom debian. Read-only, no root squash. TFTP (/export/testbox-tftp) ============================ The testbox-tftp share needs to be writable, root squashing is okay. We need files from both PXELINUX and SYSLINUX to make this work now. On a debian system, the ``pxelinux`` and ``syslinux`` packages needs to be installed. We actually do this further down when setting up the nfsroot, so it's possible to get them from there by postponing this step a little. On debian 8.6.0 the PXELINUX files are found in ``/usr/lib/PXELINUX`` and the SYSLINUX ones in ``/usr/lib/syslinux``. The initial PXE image as well as associated modules comes in three variants, BIOS, 32-bit EFI and 64-bit EFI. We'll only need the BIOS one for now. Perform the following copy operations:: cp /usr/lib/PXELINUX/pxelinux.0 /mnt/testbox-tftp/ cp /usr/lib/syslinux/modules/*/ldlinux.* /mnt/testbox-tftp/ cp -R /usr/lib/syslinux/modules/bios /mnt/testbox-tftp/ cp -R /usr/lib/syslinux/modules/efi32 /mnt/testbox-tftp/ cp -R /usr/lib/syslinux/modules/efi64 /mnt/testbox-tftp/ For simplicity, all the testboxes boot using good old fashioned BIOS, no EFI. However, it doesn't really hurt to be prepared. The PXELINUX related files goes in the root of the testbox-tftp share. (As mentioned further down, these can be installed on a debian system by running ``apt-get install pxelinux syslinux``.) We need the ``*pxelinux.0`` files typically found in ``/usr/lib/PXELINUX/`` on debian systems (recent ones anyway). It is possible we may need one ore more fo the modules [1]_ that ships with PXELINUX/SYSLINUX, so do copy ``/usr/lib/syslinux/modules`` to ``testbox-tftp/modules`` as well. The directory layout related to the configuration files is dictated by the PXELINUX configuration file searching algorithm [2]_. Create a subdirectory ``pxelinux.cfg/`` under ``testbox-tftp`` and create the world readable file ``default`` with the following content:: PATH bios DEFAULT local-boot LABEL local-boot LOCALBOOT This will make the default behavior to boot the local disk system. Copy the ``testbox-pxe-conf.sh`` script file found in the same directory as this document to ``/mnt/testbox-tftp/pxelinux.cfg/``. Edit the copy to correct the IP addresses near the top, as well as any linux, TFTP and PXE details near the bottom of the file. This script will generate the PXE configuration file when performing maintenance on a testbox. Images and logs (/export/testbox-backup) ========================================= The testbox-backup share needs to be writable, root squashing is okay. In the root there must be a file ``testbox-backup`` so we can easily tell whether we've actually mounted the share or are just staring at an empty mount point directory. The ``testbox-maintenance.sh`` script maintains a global log in the root directory that's called ``maintenance.log``. Errors will be logged there as well as a ping and the action. We use a directory layout based on dotted decimal IP addresses here, so for a server with the IP 10.40.41.42 all its file will be under ``10.40.41.42/``: ```` The name of the testbox (empty file). Help finding a testbox by name. ``testbox-info.txt`` Information about the testbox. Starting off with the name, decimal IP, PXELINUX style hexadecimal IP, and more. ``maintenance.log`` Maintenance log file recording what the maintenance service does. ``disk-devices.lst`` Optional list of disk devices to consider backuping up or restoring. This is intended for testboxes with additional disks that are used for other purposes and should touched. ``sda.raw.gz`` The gzipped raw copy of the sda device of the testbox. ``sd[bcdefgh].raw.gz`` The gzipped raw copy sdb, sdc, sde, sdf, sdg, sdh, etc if any of them exists and are disks/SSDs. Note! If it turns out we can be certain to get a valid host name, we might just switch to use the hostname as the directory name instead of the IP. Debian NFS root (/export/testbox-nfsroot) ========================================== The testbox-nfsroot share should be read-only and must **not** have root squashing enabled. Also, make sure setting the set-uid-bit is allowed by the server, or ``su` and ``sudo`` won't work There are several ways of creating a debian nfsroot, but since we've got a tool like VirtualBox around we've just installed it in a VM, prepared it, and copied it onto the NFS server share. As of writing debian 8.6.0 is current, so a minimal 64-bit install of it was done in a VM. After installation the following modifications was done: - ``apt-get install pxelinux syslinux initramfs-tools zip gddrescue sudo joe`` and optionally ``apt-get install smbclient cifs-utils``. - ``/etc/default/grub`` was modified to set ``GRUB_CMDLINE_LINUX_DEFAULT`` to ``""`` instead of ``"quiet"``. This allows us to see messages during boot and perhaps spot why something doesn't work on a testbox. Regenerate the grub configuration file by running ``update-grub`` afterwards. - ``/etc/sudoers`` was modified to allow the ``vbox`` user use sudo without requring any password. - Create the directory ``/etc/systemd/system/getty@tty1.service.d`` and create the file ``noclear.conf`` in it with the following content:: [Service] TTYVTDisallocate=no This stops getty from clearing VT1 and let us see the tail of the boot up messages, which includes messages from the testbox-maintenance service. - Mount the testbox-nfsroot under ``/mnt/`` with write privileges. (The write privileges are temporary - don't forget to remove them later on.):: mount -t nfs myserver.com:/export/testbox-nfsroot Note! Adding ``-o nfsvers=3`` may help with some NTFv4 servers. - Copy the debian root and dev file system onto nfsroot. If you have ssh access to the NFS server, the quickest way to do it is to use ``tar``:: tar -cz --one-file-system -f /mnt/testbox-maintenance-nfsroot.tar.gz . dev/ An alternative is ``cp -ax . /mnt/. && cp -ax dev/. /mnt/dev/.`` but this is quite a bit slower, obviously. - Edit ``/etc/ssh/sshd_config`` setting ``PermitRootLogin`` to ``yes`` so we can ssh in as root later on. - chroot into the nfsroot: ``chroot /mnt/`` - ``mount -o proc proc /proc`` - ``mount -o sysfs sysfs /sys`` - ``mkdir /mnt/testbox-tftp /mnt/testbox-backup`` - Recreate ``/etc/fstab`` with:: proc /proc proc defaults 0 0 /dev/nfs / nfs defaults 1 1 10.42.1.1:/export/testbox-tftp /mnt/testbox-tftp nfs tcp,nfsvers=3,noauto 2 2 10.42.1.1:/export/testbox-backup /mnt/testbox-backup nfs tcp,nfsvers=3,noauto 3 3 We use NFS version 3 as that works better for our NFS server and client, remove if not necessary. The ``noauto`` option is to work around mount trouble during early bootup on some of our boxes. - Do ``mount /mnt/testbox-tftp && mount /mnt/testbox-backup`` to mount the two shares. This may be a good time to execute the instructions in the sections above relating to these two shares. - Edit ``/etc/initramfs-tools/initramfs.conf`` and change the ``MODULES`` value from ``most`` to ``netboot``. - Append ``aufs`` to ``/etc/initramfs-tools/modules``. The advanced multi-layered unification filesystem (aufs) enables us to use a read-only NFS root. [3]_ [4]_ [5]_ - Create ``/etc/initramfs-tools/scripts/init-bottom/00_aufs_init`` as an executable file with the following content:: #!/bin/sh # Don't run during update-initramfs: case "$1" in prereqs) exit 0; ;; esac modprobe aufs mkdir -p /ro /rw /aufs mount -t tmpfs tmpfs /rw -o noatime,mode=0755 mount --move $rootmnt /ro mount -t aufs aufs /aufs -o noatime,dirs=/rw:/ro=ro mkdir -p /aufs/rw /aufs/ro mount --move /ro /aufs/ro mount --move /rw /aufs/rw mount --move /aufs /root exit 0 - Update the init ramdisk: ``update-initramfs -u -k all`` Note! It may be necessary to do ``mount -t tmpfs tmpfs /var/tmp`` to help this operation succeed. - Copy ``/boot`` to ``/mnt/testbox-tftp/maintenance-boot/``. - Copy the ``testbox-maintenance.sh`` file found in the same directory as this document to ``/root/scripts/`` (need to create the dir) and make it executable. - Create the systemd service file for the maintenance service as ``/etc/systemd/system/testbox-maintenance.service`` with the content:: [Unit] Description=Testbox Maintenance After=network.target Before=getty@tty1.service [Service] Type=oneshot RemainAfterExit=True ExecStart=/root/scripts/testbox-maintenance.sh ExecStartPre=/bin/echo -e \033%G ExecReload=/bin/kill -HUP $MAINPID WorkingDirectory=/tmp Environment=TERM=xterm StandardOutput=journal+console [Install] WantedBy=multi-user.target - Enable our service: ``systemctl enable /etc/systemd/system/testbox-maintenance.service`` - xxxx ... more ??? - Before leaving the chroot, do ``mount /proc /sys /mnt/testbox-*``. - Testing the setup from a VM is kind of useful (if the nfs server can be convinced to accept root nfs mounts from non-privileged clinet ports): - Create a VM using the 64-bit debian profile. Let's call it "pxe-vm". - Mount the TFTP share somewhere, like M: or /mnt/testbox-tftp. - Reconfigure the NAT DHCP and TFTP bits:: VBoxManage setextradata pxe-vm VBoxInternal/PDM/DriverTransformations/pxe/AboveDriver NAT VBoxManage setextradata pxe-vm VBoxInternal/PDM/DriverTransformations/pxe/Action mergeconfig VBoxManage setextradata pxe-vm VBoxInternal/PDM/DriverTransformations/pxe/Config/TFTPPrefix M:/ VBoxManage setextradata pxe-vm VBoxInternal/PDM/DriverTransformations/pxe/Config/BootFile pxelinux.0 - Create the file ``testbox-tftp/pxelinux.cfg/0A00020F`` containing:: PATH bios DEFAULT maintenance LABEL maintenance MENU LABEL Maintenance (NFS) KERNEL maintenance-boot/vmlinuz-3.16.0-4-amd64 APPEND initrd=maintenance-boot/initrd.img-3.16.0-4-amd64 ro ip=dhcp aufs=tmpfs \ boot=nfs root=/dev/nfs nfsroot=10.42.1.1:/export/testbox-nfsroot LABEL local-boot LOCALBOOT Troubleshooting =============== ``PXE-E11`` or something like ``No ARP reply`` You probably got the TFTP and DHCP on different machines. Try move the TFTP to the same machine as the DHCP, then the PXE stack won't have to do any additional ARP resolving. Google results suggest that a congested network could use the ARP reply to get lost. Our suspicion is that it might also be related to the PXE stack shipping with the NIC. ----- .. [1] See http://www.syslinux.org/wiki/index.php?title=Category:Modules .. [2] See http://www.syslinux.org/wiki/index.php?title=PXELINUX#Configuration .. [3] See https://en.wikipedia.org/wiki/Aufs .. [4] See http://shitwefoundout.com/wiki/Diskless_ubuntu .. [5] See http://debianaddict.com/2012/06/19/diskless-debian-linux-booting-via-dhcppxenfstftp/ ----- :Status: $Id: TestBoxImaging.txt 106065 2024-09-16 21:42:41Z vboxsync $ :Copyright: Copyright (C) 2010-2024 Oracle Corporation.